Kit Includes

Tolls needed

1. 8) spacers (6 large/2 small).
2. 8) X-long SS screws.
3. 4) 12" long pieces of self adhesive high density rubber foam.
4. 4) 12" long pieces of self adhesive EPDM  rubber weather-strip.

1. #15 Torx
2. Cutters
3. Philips screwdriver
4. Scissors
5. Cleaner ( I use rubbing alcohol )

Remove taillights with #15 Torx      *Notice the 2 tabs on the ends.

Cut tabs off with cutters

Skip this step if you have Euros.

The shaped spacer now fits.

Clean the taillight opening with alcohol.

Apply the self-adhesive rubber foam tape on the bottom part of the taillight hole against the lip as shown.

Apply the self adhesive EPDM  rubber weather-strip next to the rubber foam.

You can trim some of the excess foam and rubber from the ends.

Place blocks as shown and using the long SS Philips screws install your taillights.

Note that you have (2) blocks that are smaller than the other (6). Theses are used at the far ends of the outside taillights.